Description

If you are putting in an aftermarket Fuel tank, then you often need a breather kit to keep the juices flowing.

These breather kits consist of the following:

• 90 Degree 1/4″ Barb with 1/4 NPT Thread
• Billet Breather Cap
• 2ft of 2.5mm Cloth covered fuel hose to suit
• 1 Roll of Fuel Approved Sealing Tape
• 2 x small cable ties.

When you get the kit you will need to drill and tap a 1/4 NPT Thread into your tank at the highest point and thread in the Brass fitting with the supplied thread tape to ensure a good seal. Once in place push the supplied hose on and run it to your preferred location. The Billet breather cap must be mounted in the upright position with the hose going vertical down.

The ideal position for the breather is as high as you can get it relative to the tank.